racd60-a rohs 2011/65/eu 6/6 lightline ac/dc-converter with 5 year warranty 60 watt pfc single output selection guide input voltage range 90-305 vac input frequency range 47-63hz power factor (full load) 120vac >0.98 240vac >0.94 277vac >0.92 thd full load, 115vac 12% max. full load, 230vac 18% max. dc dimming dc 1-10v pwm dimming puls: hi=10v low=0v, duty: 10% - 100%, fsw 0.5 - 3khz resistance dimming 10k - 100k current accuracy 5% ac input current 100-240vac 0.8a 277vac 0.4a inrush current (cold start) 240vac 70a leakage current <0.5ma / 240vac start-up time (at full load) <2sec isolation voltage 3.75kvac / 1 minute short circuit protection hiccup over voltage protection 12v 13.2 - 15.6v 24v 26.4 - 31.2v 36v 39.6 - 46.8v 48v 52.8 - 62.4v 57v 62.7 - 70v over temperature protection 105 10c , latch mode vibration 10-500hz, 2g, 60 min. along x, y and z storage humidity 10% - 90% rh operating humidity 20% - 90% rh non-condensing weight 420g operating temperature -30c to +50c storage temperature -40c to +60c ripple & noise 12v, 24v 200mv (at 20mhz bandwidth using 0.1uf & 47uf capacitor) 36v, 48v, 57v 250mv ip rating ip67 isolation resistance 100m / 500vdc at 25c dimension (l*w*h) 179*45.1*32.5mm design lifetime 70 x 103 hours max. mtbf (+25c) using mil-hdbk 217f 200 x 103 hours min. continued on next page specifications (measured at 230vac and 25c ambient temperature) universal ac input constant current operation suitable for high brightness led products built-in active pfc function overvoltage-, short circuit- and over- temperature protection built-in 3 in 1 dimming ip67 rated class 2 power unit ul1310 features led driver part output rated rated output efficiency number voltage power current voltage range (vdc) (w) (ma) (v) (typ.) racd60-1050a 57 60 105 - 1050 40 - 57 88% racd60-1200a 48 58 120 - 1200 33 - 48 88% RACD60-1650A 36 60 165 - 1650 24 - 36 87% racd60-2500a 24 60 250 - 2500 15 - 24 86% racd60-4200a 12 50 420 - 4200 9 - 12 86% en 61347-1 certified en 61347-2-13 certified ul8750 certified a a ,a -a /+a 0* -+ + ) # ; 3a *2)
$ e340696 refer to application notes derating-graph (ambient temperature) note: all led drivers may not be used without a load. they must be switched on the primary side only. noncompliance may damage the led or reduce its lifetime. l-54 www.recom-power.com rev: 0/2015
racd60-a specifications (measured at 230vac and 25c ambient temperature) racd60-a series lightline ac/dc-converter safety standards led lighting safety report: e340696 ul8750 led lighting safety (canada) report: e340696 cul8750 class 2 power supply safety report: e340696 ul1310 extra low-voltage class 2 output report: e340696 csa c22.2 no. 223-m91 led equipment for lighting application report: e340696 csa c22.2 no. 250.13-12 en61347-1 en61347-2-13 en61000-3-2 class c en61000-3-3 en61000-4-2,3,4,5,6,8,11 en61547 en55015 fcc15 3 in 1 dimming control (dc / pwm / resistance) 10k-100k resistor dimmable (typical): resistor single-driver 10k 20k 30k 40k 50k 60k 70k 80k 90k 100k multi-driver 10k/n 20k/n 30k/n 40k/n 50k/n 60k/n 70k/n 80k/n 90k/n 100k/n iout (%) 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% the length of extended wire for dim+/- shall not exeed 20 meters. (wire 20m) n = the number of dimmer drivers should not exceed 15. (n 15ms) dc: 10v / pwm dimmable (typical) dc: 1-10v dimmable (typical) $ $ ! !
%!
%
( $ $ ) *
*#
(
( $
%!
% +,, #
#*
( $ ' '
%
%
% efficiency vs load over vin racd60-2500a package style & pinning typical characteristics -, : &
( ,+% )89 @# 18 *. : &
( *%+ %. 4## # , * %+ ) %. %. #( - *+%/ . - / c+ - c+ 217 204
(> 14
0 )94
)45 . / c+ - - c+ 9 g 0 20
$(( . * * . * www.recom-power.com l-55 rev: 0/2015 the product information and specifications are subject to change without prior notice. recom products are not authorized for us e in safety-critical applications (such as life support) without recoms explicit written consent. a safety-critical application is defined as an applica tion where a failure of a recom product may reasonably b e expected to endanger or cause loss of life, inflict bodily harm or damage property. the buyer shall indemnify and hold harmless recom, its affiliated companies and its representatives against any damage claims in connecti on with the unauthorized use of recom products in such safety-critical applications. maximum number of led drivers per circuit breakers condition circuit breaker circuit breaker current typ 10a 16a 20a 25a 115vac, 1ohm 90 phase angle c 12 20 24 31 230vac, 1ohm 90 phase angle b 13 21 25 32 c 21 35 41 51 277vac, 1ohm 90 phase angle b 15 24 29 37 c 24 40 47 58
|
